The Interior Trays are used to mount electronics. They all have the same mounting hole pattern so they can be stacked in any order using standoffs.

The smallest Interior Tray is rectangular shaped and is ordinarily used at the lowest level to mount a flight controller over the ESC. For this reason this tray is referred to this tray as the “Flight Controller Tray.”

The two larger trays are octagonal shaped and can be used for mounting electronic components. These trays have a width of 89 mm and 99 mm. These trays refer to these trays as “Equipment Trays.”

The 89 mm tray will fit inside the Fuselage Lid’s large “dome.”

All these trays can be printed with PLA. They do not require high strength. Stiff and rigid filaments will reduce the chance of vibration.

• Download STL of Flight Controller Tray
• Download STL of 89 mm Equipment Tray
• Download STL of 99 mm Equipment Tray

These Interior Trays can be printed flat on a build plate without supports. Stiff PLA is recommended.